![edgrouter x run a ping console edgrouter x run a ping console](https://geekculture.co/wp-content/uploads/2020/10/xbox-royale-gaming-chair-1-1.jpg)
Router's Ethernet interface, destined for the network that the TFTP server Routers, configure the sources to be translated using extended access list 100.Īccess list 100 should match traffic sourced from the network on your edge Its local TFTP server network 10.254.0.0. It does not have any remote routes for the pod 10. Internal router Ethernet address using either 192.168. In this task, you will configure one-to-one NAT using an access list on theĮdge routers (P xR1 or P xR2). Verify connectivity to the Ethernet-attached edge
![edgrouter x run a ping console edgrouter x run a ping console](https://noobient.com/wp-content/uploads/2018/08/Clipboard03-2.png)
1.1, and P x R2 has an Ethernet address ofġ0. The Ethernet interface, and enable the interface. To clear the configuration and reload the router.Ĭonnect to your internal routers. Present, use the erase start and reload commands In this task, you will connect the internal routers in your pod, P xR3Īnd P xR4, to the edge routers, P xR1 and P xR2. Task 1: Connecting the Internal Router to the Edge Router
![edgrouter x run a ping console edgrouter x run a ping console](https://i.imgur.com/OagnW0U.png)
Starts the console display of translation entries being Specifies a route map to be used for NAT. (config)# ip nat inside source route-map TO_POD Removes all address translations from the NAT Translates inside addresses that match the access listĬreates a default route pointing out interfaceĬreates a route map to match the source address with 0 0.0.0.255 10.254.0.0 0.0.0.255Ĭreates an access list that specifies the traffic thatĬreates a named pool of addresses for use by Table 1-6 NAT Configuration Exercise Commandsġ0.1. Visual objective diagram for addressing details. Be careful whenĪddressing your routers! Refer to the exercise instructions and the appropriate Typically for the P xR1 and P xR3 routers. Although the command syntax is shown in this table, the addresses shown are